Workrite Ergonomics | 800.959.9675 www.workriteergo.com
5 of 10
Attach Base to Non-Workrite
Worksurface
Note: For 2-Leg Corner and 120° Worksurface
Mounting Instructions, go to:
www.workriteergo.com/instructions
Position Leg Assembly 2.875" from
the side edges and 6.125" from the
front on 23" to 30" worksurfaces,
making sure the frame runs
parallel with the back edge of the
worksurface.
Use a ⅛" drill bit to drill
pilot holes at the four
corner locations. You may
wish to mark your drill
bit so you do not drill any
more than ¾" deep and
damage your worksurface
top.
Do not drill all the way through worksurface!
Attach at the four corner locations
using #12 × ¾" Pan Head Laminate
Top Screws (G). If you use an
electric screwdriver, be sure it is on
the lowest torque setting to avoid
stripping the holes in the top.
With frame set positioned
and the four corner screws
secure, drill pilot holes first
then attach the frame set
using the remaining #12×¾"
Pan Head Laminate Top
Screws (G).
Tighten securely.
>¾"
6
.125"
2.87
5"
2.87
5"
6
.125"
23
"– 30"
Parallel t
o edge
front
4
a
b
a
a
b
b
b
b
G
G
G
G
3 screws per
Short Bracket
2 screws per End Bracket
(2 installed in Step 4c)
c
d
d
d
c
c
c
c
Note: Avoid trip or tip hazards!
For uniquely shaped, non-rectangular worksurfaces, it is the
installers responsibility to position the worksurface to minimize
extended overhangs and position feet fully under the worksurface.
G
#12 × ¾" Pan Head
Laminate Top Screw
Hardware at actual size
