6 of 11 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
>¾"
6.5"
23"– 30"
23"– 30"
2.875"
6.5"
2.875"
Position the connected stretcher leg assembly as shown 6.5"
in from the rear edge of the outside corner of the top and
2.875" in from the side. Make sure the legs and stretchers
are parallel with the back edge of the worksurface.
Position the floating stretcher leg assembly as shown 6.5"
in from the rear edge of the outside corner of the top and
2.875" in from the side. Make sure the legs and stretchers
are parallel with the back edge of the worksurface.
Using the ⅛" drill bit, drill ¾" deep pilot holes in the six
corner locations.
Note: We recommend you mark your drill bit at ¾" to
prevent drilling too deep.
Caution: Do not drill through the worksurface!
Install six (6) #12 × ¾" Phillips pan head screws (Q)
into the 6 corner locations and tighten securely.
Warning: Do not over-tighten and strip the screws
into the top!
Using the ⅛” drill bit, drill ¾” deep pilot holes in the
remainig locations in the brackets on the legs.
Install #12 × ¾" Phillips pan head screws (Q) into all
pilot holes and tighten securely.
ATTACH BASE ASSEMBLIES TO TOP
4.1
4.2
4.3
4.4
4.5
4.6
4
Q
#12 × ¾" Phillips Pan Head
Screws
Hardware at actual size
4.5
4.6
4.4
4.2
4.1
4.3
Q
Q
Floating Stretcher
Bracket
Connected
Stretcher
Bracket
K
K
