2⅞"
6⅛"
2⅞"
6⅛"
4 screws per
End Bracket
3 screws per
Short Bracket
4 of 8
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables
Attach Base to Worksurface and Tighten Screws
If you do not have a Workrite
worksurface skip to step
4
If you have a Workrite worksurface:
Position leg assemblies to align mounting
holes in brackets to pre-drilled holes in
Top (A) then attach loosely using Pan
Head Top Screws (K). If you use an
electric screwdriver, be sure it is on the
lowest torque setting to avoid stripping
the holes in the top.
Tighten all screws connecting
brackets to leg assemblies.
Then tighten all screws attaching
brackets to top.
Continue to Step
5
.
Attach Base to Worksurface and Tighten Screws (continued)
If you do not have a
Workrite worksurface:
Position leg assemblies on
bottom side of worksurface
using measurements
a
below.
Mark placement of mounting
holes, then use ⅛" drill bit
to drill pilot holes at marked
locations. You may wish to
mark your drill bit so you
do not drill any more than
¾" deep and damage your
worksurface top.
Do not drill all the way
through worksurface!
front
A
3
a
b
c
4
a
b
b
a
a
c
B
C
B
A
K
K
