Assemble Desk Mount
1
Install the Extension Pole (A) into
the threads in the mount and tighten
securely.
Insert 2 Set Screws (G) into the rear
of the base and tighten securely with
the 2.5mm Hex Wrench (I)
2
b
b
a
a
Attach Extension Pole, Cable Manager & Collar
C-Clamp Mount:
Note: If you have easy access you can assemble the clamp
before placing it onto the work surface and tightening it
down.
Place the Clamp Base (T) over the rear edge of the
workstation. Attach the Clamp Bracket to the Clamp Base
with 4 M6 × 10mm Alan Cap Bolts (V) and tighten with
6mm Hex Wrench (S)
Grommet Mount:
Note: A grommet hole or small drilled hole from 3/8”
diameter to a grommet hole up to 2.5” diameter is required
to mount the grommet mount.
Place the Grommet Mount Base (U) over the grommet hole
or drilled hole in the worksurface. From the bottom place
the bolt (X) through the Grommet Clamp Plate (W) and
tighten securely with the 6mm Hex Wrench (S)
Install Cable Manager (B) onto the
Pole and slide down to the bottom.
Place Collar (C) onto the pole about
6” up from the bottom and install Set
Screw (G) and tighten securely.
V
S
S
U
W
X
T
G
G
A
B
I
C
G
