1500411 Rev A
4 of 4
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
6
Mount Monitors to VESA Plate
If possible, use the included Monitor Mount screws to attach your
monitor to the VESA plate. Otherwise use the shortest screws
possible from the included hardware kit (K or L) .
7
Monitor Tilt Capacity Adjustment
If your monitor is too light or too heavy for the
factory set capacity, the monitor will tilt too easily. If
this is the case, you need to adjust the tension.
7.1 Adjusting Tilt Capacity
To increase ca) turn
clockwise
using the
5 mm Allen wrench (J) until the monitor reaches a
balanced adjustment.
To decrease capacity(-) turn
counter-clockwise
until
the monitor reaches a balanced adjustment.
7.2 Adjusting Arm Capacity (opposite of above)
To increase ca) turn
counter-clockwise
using
a 5 mm Allen Wrench (J) until the arm reaches a
balanced adjustment.
To decrease capacity(-) turn
clockwise
until the arm
reaches a balanced adjustment
100 mm VESA standard,
use 4 outer corner holes.
Important Note:
It is strongly recommended to use
the mounting screws provided by the monitor manufacturer
if possible. If longer screws are required, use the shortest
screws possible to avoid damage to the monitor.
75 mm VESA standard,
use 4 inner corner holes.
Remove
Tilt capacity
Arm capacity
7.1
7.2
K
L
Screws that came
with monitor or
or
