1 of 4
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
K
Monitor Screws, Medium
Qty: 4
L
Monitor Screws, Short
Qty: 4
H
M2.5 Allen wrench
Qty: 1
I
M4 Allen wrench
Qty: 1
J
M5 Allen wrench
Qty: 1
F
Conform Sit-Stand
Articulating Arm
Qty: 1
G
Pivot Cover Cap
Qty: 1
A
14" Pole with
HD Base
Qty: 1
E
Single Pole Adaptor
Qty: 1
C
Grommet Bolt, Wing
Nut & M8 Steel Washer
Qty: 1
D
U-Bracket
Qty: 1
Parts Included
Assembly & Installation Instructions:
Conform Sit-to-Stand Arm CONF-STS-WOPB-S
Tools Supplied
Monitor Hardware
1
HD Base C-Clamp Installation
Note: If you are installing using a grommet, skip to Step 2.
1.1 Using C-Clamp handle, loosen the C-Clamp on the Pole Base (A) wide enough
to fit over the edge of the worksurface.
1.2 For thinner tops: Adjust the C-Clamp lower plate if it is too wide to fit over
the edge of the worksurface. To adjust, remove the screws using the 5 mm
Allen wrench (J). Slide the C-Clamp lower plate to the upper screw holes,
replace the screws and tighten until secure.
1.3 Remove Adhesive Pad (B) backing. Apply the pad to the bottom surface of
the base, adhesive side up, so that it aligns with the front edge of the base
and sticks in place.
1.4 Place C-Clamp over the rear edge of the worksurface and tighten the clamp
by turning the C-Clamp Bolt until secure.
Skip to
Step 3.
B
Adhesive Pads
Qty: 1
CONF-PB-14HDCCG-S
1.1
Tighten
Tighten
Loosen
Loosen
A
A
J
B
1.2
1.3
1.4
For thinner tops
