5
6. OPERATION
6.1 Operation
• Check that a glue stick is fitted (see
point 5.2)
• Long press the ON/OFF switch (1) for
approx. 2 seconds.
• The LED (2b) will light up red to indicate
that the equipment is heating up
• This takes approx. 100 seconds, after
which the LED (2b) changes to green
• The equipment is now ready for
operation.
• To switch the equipment off again,
press the ON/OFF briefly just the once
Warning!
Never set the equipment down once you
have started using it.
If or when your gluing work is interrupted or
finished,always be sure to stand the
equipment on its fold up stable stand as
shown in Fig.1. Switch the equipment off
and allow it to cool down completely
before you pack it away.
6.2 Working with the cordless hot glue
gun
• You can now apply the glue by pressing
the trigger lever (4) after the heating up
time
• Press both surfaces together immedi-
ately and apply pressure to them
• It takes about 30 seconds for the glue
to set.
The equipment switches off automati-
cally after approx. 5 minutes of non-use.
Important!
Glue stains on textiles cannot be removed.
6.3 LED indicator (Fig. 2/Item 2)
The indicator (2) displays the charging
status during charging (see point 5.1), the
heating time and when the equipment is
ready for operation (see point 6.1). If the
red LED (2a) turns to be red during
operation,the battery is empty. Recharge
the battery.
7. CLEANING AND MAINTENANCE
Warning!
Allow the equipment to cool down before
you start to clean it.
7.1 Cleaning
• Keep all safety devices, air vents and
the motor housing free of dirt and dust
as far as possible. Wipe the equipment
with a clean cloth or blow it with
compressed air at low pressure.
• We recommend that you clean the
device
immediately each time you have
finished using it.
• Clean the equipment regularly with a
moist cloth and some soft soap. Do not
use cleaning agents or solvents; these
could attack the plastic parts of the
equipment. Ensure that no water can
seep into the device. The ingress of
water into an electric tool increases the
risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment
which require additional maintenance.
8. STORAGE
Store the equipment and accessories in a
dark and dry place at above freezing
temperature. The ideal storage tempera-
ture is between 5°C(41°F) and 30°C(86°F).
Store the electric tool in its original
packaging.
