Workhorse PD3009-3, Руководство пользователя

Страница: 8 / 28

Assembly
Step 3: Installing and Tracking the Belt
Parts needed:

Belt

Threading Pin
1. When first installing the belt, on the
infeed side of the dryer, remove the top
nut and bolt holding the infeed roller in
place. Once removed, loosen the bottom
nut, but keep in place. After loosening the
bottom nut, roll the infeed roller forward
so there is less tension on the belt when
installing the pin.
1. 1.
2. Feed the belt from the outfeed side of
the dryer, through the top of the
chamber. Pull the belt through the
infeed side and over the infeed roller.
2.
3. Run the belt under the infeed roller
and then above the tension roller and
above the lower support. Then feed the
belt through the lower portion of the
chamber and out the outfeed side of the
dryer. 3.
3.
4. On the tablet side of the dryer,
line up the yellow marks on the
teeth. Push the pin through the
teeth making sure to have the
same amount of extra pin on
both sides.
4. 4.
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779 Workhorseproducts.com
8