ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR HAMMER DRILL
•
Wear protective goggles.
When working, sparks or flying splinters, shavings, and dust can cause loss of vision.
WARNING
–
To reduce the risk of injury, user must read instruction manual
Environmental Protection
Waste electrical products should not be disposed of with house hold waste Please recycle where facilities
exist. Check with your local Authority or retailer for recycling advice.
Attention!
Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the
EQUIPMENT. This can influence other equipment (eg. Blinking of a lamp). If the MAINS-IMPEDANCE
Z
max
<0.195OHM, such disturbances are not expected. (In case of need, you may contact your local supply
authority for further information).
Accessories Standard Accessories
1. Pointed Shovel 22X320mm
2. Drill Bit 22X320mm
SPECIFICATION
Rated Voltage 220V
Frequency 50Hz
Rated Input Power 1600W
No-Load Speed 0-560r/min
Max-Impact-rates 3530bpm
APPLICATIONS
Crushing concrete, chipping, digging, and squaring. (Application Examples)
Installation of piping and wiring, sanitary facility installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other civil engineering work.
PRIOR TO OPERATION
1.
Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product
nameplate.
2.
Grounding
This tool should be grounded while in use to product the operator from electric shock. The tool is equipped
with a three conductor cord and grounding type pug to fit the proper grounding type receptacle. The green
or yellow) wire to a live terminal.
3.
Power switch (5)
Ensure that the power switch in the OFF position. If the plug is connected to a power receptacle while the
power tool while start operating immediately, inviting serious accident.
