User manual
Hoof trimmingcrush:SA0051/SA0051B
Version: 21-02-17
Page 20 of 33
11. Remove the lighting
board.
Remove the lighting board from the
crush.
12. Lower the rear
adjusting feet.
Lower the 2 rear adjusting feet (Figure
4:1) by pushing them down with the
foot and lock them at the desired
height with the chain.
13. Tip the axle.
Lift the axle cylinder locking
mechanism.
Operate the valve until the wheels are
folded up.
14. Install the side gates.
Withdraw the side gates (Figure 4:2)
from the crush and place them in the
desired position.
4.2. Connect the machine.
CAUTION
Check that the voltage specified on the machine plate matches the mains
supply.
The machine must always be connected to an earthed socket to avoid the
risk of fire or electric shocks (the earth connection is coded green/yellow).
The electrical installation including the sockets must be connected in
accordance with local regulations.
The power cable must always be free and nothing must be placed on top of
it.
Replace the power cable immediately if it is damaged.
4.3. Preparing for transportation.
CAUTION
Preparing for transportation is the reverse procedure to making ready for
use (see 4.1).
With crushes equipped with an axle and drawbar it is essential that all
locking mechanisms are correctly installed.
