Woodway Engineering Ltd
Lower Road, Barnacle
Coventry, CV7 9LD
United Kingdom
Tel: +44 (0) 24 76 841750
Fax: +44 (0) 24 76 621796
www.woodwayengineering.com
I N S T A L L A T I O N G U I D E
10
®�
WeCan® Connection
Mount the lightbar to the roof of the vehicle following the steps in the supplied lightbar Installation Guide.
The CenCom Sapphire™ UK is focused towards the use of any lightbar from the WeCAN™ range.
1
2
3
4
4
3
2
1
3
1 2 3 4 5 6 7 8
10 7 4
2 1
12 9 6 3
2
1
6 5 4
3
1
1
7
8
14
To wire the lightbar to the CenCom Sapphire™ UK, connect the lightbars attached Red power wire to the battery’s ‘Positive’ (+) terminal
and the Black power wire to ‘Ground’ (-). Ensure that you install a fuse and that the correct rating for your fitted lightbar (see lightbar
Installation instructions if unsure), is fitted in line with your Red power wire as close to the battery terminal as possible. If wires need to
be extended, ensure that the wire used is correctly rated for the necessary current (recommended 125% of maximum current draw).
Run the Green (CAN High) and Grey (CAN Low) WeCan® wires to the CenCom Sapphire™ UK Using the supplied 3 Way WeCan®
screw terminal plug supplied. Using Ferrule crimps screw the wires into the 3 Way Plug using the following connections:
Pin 1 = GREEN CAN High
Pin 2 = SHIELD
Pin 3 = GREY CAN Low
With the three wires securely fastened into the 3 Way plug, it can then be connected to plug J of the CenCom Sapphire™ UK by firmly
mating the two connectors together.
The lightbar flash patterns can now be programmed using the supplied CenCom Sapphire™ UK programming software.
