
34 | UM-BS-EN-A3
8.2.1
Functional Test
A complete function test of the BOOST must be carried out depending on the duration and intensity
of use.
The function test includes the following:
1.
Put on a pair of BOOST shorts and zip yourself into the device. Operate the
display to provide air pressure. (See Section 7.4) Straddle the running
surface for the remaining steps below. (Feet on side covers; not running.)
2.
Turn up treadmill to max. speed for a short time. Does the treadmill reach
the specified max. speed? Do unusual noises occur?
3.
Does the display correctly show the distance traveled at top speed?
4.
Stop the treadmill and move it to max. incline. Does the treadmill reach the
desired incline?
5.
Do unusual noises occur while the treadmill is running at max. incline?
6.
Check the emergency stop magnetic switch function. Is an emergency stop
initiated?
7.
Check the function of the emergency stop mushroom and/or button, if
applicable.
8.
Turn off treadmill display. Though slight movement is normal, the running
surface must be very difficult to move. Is the running surface stopped
correctly?
ATTENTION
If there are defects or deviations in the control function, notify WOODWAY
Customer Service immediately.
The device must be taken out of service and disabled until repaired. Repairs
may only be carried out by trained and authorized personnel.
For further information on maintenance procedures, refer to the separate service manual.