Woodward easYgen-3000XT Series, Руководство пользователя, Страница: 414 / 1205

ID Parameter CL Setting range
[Default]
Description
This parameter is only effective if
start stop mode (parameter
╚═▷
5752 ) is configured to "Generator
load".
Refer to parameter ╚═▷ 5757 for
examples on stating and stopping
a genset depending on the
dynamic setting.
5772 MOP Add on delay 2 0 to 32000 s
[20 s]
Load swings may exceed the
threshold momentarily. In order to
prevent the engine from starting
due to short-term load swings, a
delay time may be configured.
The LDSS criterion for adding load
must be exceeded without
interruption for this delay time,
configured in seconds, prior to a
start command being issued.
If the LDSS criterion for adding
load is fallen below before the
delay time expires, the delay time
is reset and a start command is
not issued.
5773 MOP Add on delay at
rated load 2 0 to 32000 s
[3 s]
The command to start the next
genset in case a genset exceeds
rated load will be issued after the
delay configured here has expired.
This parameter becomes only
effective in case a genset exceeds
rated load to achieve a faster start
and overrides parameter
╚═▷
5772 .
Notes
This parameter becomes only
effective in case a genset exceeds
rated load to achieve a faster start
and overrides parameter
╚═▷
5764 .
5774 MOP Add off delay 2 0 to 32000 s
[60 s]
Load swings may fall below the
threshold momentarily. In order to
prevent the engine from stopping
due to short-term load swings, a
delay time may be configured.
The load must remain below the
hysteresis setpoint without
interruption for the delay time,
configured in seconds, prior to a
stop command being issued.
If the load exceeds the hysteresis
setpoint before the delay time
expires, the delay time is reset
and a stop command is not
issued.
414 easYgen-3000XT Series B37574
4 Configuration
4.4.5.5.5 Mains Parallel Operation
Released