Woods Mov'n Machine FZ23B, Руководство оператора

Страница: 7 / 54

Safety 7
MM F-Series (Rev. 8/1/2008)
(Safety Rules continued from previous page)

Installation of a grasscatcher assembly will
reduce the stability and maneuverability of the
Mow'n Machine when operating on sloping terrain.

Do not tow a trailer over 200 lbs. Do not tow a
trailer or add power unit ballast with a combined
weight over 200 lbs. Too much weight can cause
loss of traction or stability on a slope. It can also
reduce parking brake ability. Too much weight will
shorten the hydraulic system life. Never tow a
trailer with a grass collection system attached to
the power unit.

Watch for hidden hazards on the terrain during
operation.

Watch for traffic when operating near or cross-
ing roadways.

Uneven terrain could overturn the machine.

Do not try to stabilize the machine by putting
your foot on the ground.

Do not mow near drop-offs, ditches, or embank-
ments. The machine could suddenly roll over if a
wheel goes over the edge or if the edge caves in.

Stop power unit and equipment immediately
upon striking an obstruction. Turn off engine,
remove key, inspect, and repair any damage before
resuming operation.

Do not drive or operate mower in tilt-up posi-
tion. Power unit stability is not adequate and result-
ing loads can damage or cause failure of tilt-up
mechanism.

Never leave a running machine unattended.

Moving steering levers rapidly from forward to
reverse or reverse to forward could cause loss of
control.

Do not operate power unit with attachment
removed. Attachment is required for power unit
stability.

Before attempting to unplug vacuum hoses, dis-
engage PTO, stop power unit, and remove key.
MAINTENANCE

Before dismounting power unit, follow these
steps: lower attachment to ground, shut off PTO,
set parking brake, shut off engine, position steer-
ing levers to neutral swing-out position, and
remove key.

When using a sunshade and lifting hood for
maintenance, use caution around pinch points.

Before attempting to unplug vacuum hoses, dis-
engage PTO, stop power unit, and remove key.

Before performing any service or maintenance,
lower attachment to ground, turn off power unit
engine, remove key, and disconnect battery ground
cable (negative -).

Before working underneath, read manual
instructions, securely block up, and check stability.
Secure blocking prevents equipment from drop-
ping due to hydraulic leak down, hydraulic system
failure, or mechanical component failure.

Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.

Do not work on mower in tilt-up position unless
lock-up mechanism is in good condition. Replace if
damaged.

Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate
.

Make sure attachment is properly secured,
adjusted, and in good operating condition.

Do not put Mow’n Machine into service unless
clutch is working properly. When the engine is at
full throttle, PTO-driven accessories must stop
within five seconds after the PTO switch is turned
t o “ O FF. ” S e e y o ur d e a l e r f o r r e p l a c e m e n t
clutches.

Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.

Do not remove radiator cap while engine is hot.

Do not change engine governor settings or
overspeed engine.

Frequently check blades. They should be sharp,
free of nicks and cracks, and securely fastened.

Do not handle blades with bare hands. Careless
or improper handling may result in serious injury.

Your dealer can supply genuine replacement
blades. Substitute blades may not meet original
equipment specifications and may be dangerous.
(Safety Rules continued on next page)
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!