background image

SPECIFICATIONS:   

4 persons

 

 

 

Floor size: 

 

9 x 7’ (2.7 x 2.1 m)  

   Centre 

height: 

 4’2” 

(1.3 

m)

   Weight: 

  13 

lb 

1oz 

(5.93 

kg)

A

2

B

KEY
NO.

MODEL NO.  CTC160907-2(076-6067-6)

QTY.
REQ.

DESCRIPTION

Fibreglass pole - Main (Green)

HFP9.5-467f

1

1

1

1

HFP9.5-150f

HTFCTC160907-2

HMS4-7

HMS6-12

Fibreglass pole - Roof (Green)

C

HFP9.5-401f

Fibreglass pole - Fly (Gray)

Replacement Fly

Mud mat

7

4

HMM4117

1

Gear loft w/TP

HGL1210wTP

Tent Stakes

PART NO.

REPLACEMENT PARTS

A

A

B

C

CTC160907-2   8/15

TROUBLESHOOTING GUIDE

PROBLEM

CONDENSATION

SEAM LEAKAGE

MILDEW

REPAIRING A TEAR

FAULTY ZIPPER

FADING FABRIC

FLOOR CONDENSATION

USE OF STAKES

SOLUTION

Condensation occurs when warm, moist air inside tent comes in contact with cooler outside air. Avoid touching walls to reduce  contact leakage. Venting doors and 
windows will reduce condensation. Store wet clothing outside of tent. A battery-powered fan may be helpful. Not applicable to screen houses.

Apply a generous amount of seam-sealer on inside seams. Seam-sealer may be purchased at any local sporting goods store.

To avoid mildew, store tent/screen house ONLY when thoroughly dry. However, if mildew occurs use a soft-bristle brush or sponge with mild dishwashing soap or Fels 

Naptha soap to clean. Let dry thoroughly and a tent-approved water-repellent compound may be applied.

For small tears use a self-adhesive patch kit. We recommend a canvas or awning repair shop for larger tears.

Zippers are self-repairing. If the zipper separates, you can move the slider to the beginning of the zipper tape and rework the zipper. 

Do not leave up in direct sunlight longer than necessary. If left in sunlight for prolonged periods of time, fabric will fade and weaken.

A ground cloth under the floor helps prolong its life, provides additional insulation and moisture protection. The cloth should be smaller than the floor to prevent rain 
from running under the tent.  Not applicable to screen houses.

Stakes should be installed at a 45  angle using a hammer or mallet. Stake loops should be kept taut without over-stretching fabric or webbing. This could cause tears or 
leakage. To remove safely, use a hammer or stake puller. Do not remove by pulling on the fabric.

o

Содержание CTC160907-2

Страница 1: ...r assembly During assembly poles are under tension If not held firmly in place during assembly poles could break or flip up possibly causing serious injury Safety glasses may be worn throughout the assembly process as an additional precaution Exercise care when using electric devices in and near tents 2 YEAR REPLACEMENT PARTS LIMITED WARRANTY This product carries a replacement parts warranty again...

Страница 2: ... goods departments Discolouration may occur if applied to outside seams Step 3 Spread out tent insert poles 1 Spread out the tent flat floor side down 2 Position poles A so they cross at the centre of the tent Make certain the centre of the poles meet at the centre of the tent and loosely fasten the fabric ties 3 Place the roof pole B at the middle on the main poles Place the pole ends into the po...

Страница 3: ...nguished Dispose of trash appropriately Dimension A should be close to but not exceed the length of the pole bag A Fold tent into a rectangular shape Front of tent door unzipped Step 6 Stake tent 1 Stake down the tent by inserting a stake through the stake loops located along the perimeter of the tent 2 Make certain the tent floor is pulled out evenly and tightly 3 Hammer the stakes into the groun...

Страница 4: ...e purchased at any local sporting goods store To avoid mildew store tent screen house ONLY when thoroughly dry However if mildew occurs use a soft bristle brush or sponge with mild dishwashing soap or Fels Naptha soap to clean Let dry thoroughly and a tent approved water repellent compound may be applied For small tears use a self adhesive patch kit We recommend a canvas or awning repair shop for ...

Отзывы: