30
Assembly
MAN0050 (Rev. 1/16/2004)
Install Tailwheel
1.
Attach tailwheel bracket (6) to cutter at the
tailwheel pivot holes (5B) using cap screw (13) and
flange lock nut (14) previously removed.
NOTE:
Make sure grease fitting on tube is on top
when installing tailwheel.
2.
Select desired height adjustment holes (10), and
secure tailwheel bracket with cap screws (13) and
flange lock nuts (14). Cutting height adjustment will
be necessary when cutter is fully assembled. See
page 9.
3.
Raise rear of cutter and insert tailwheel assembly
(9) into tailwheel bracket (6). Secure with washer
(37) and spiral pin (28).
4.
Place diagonal brace bars (4) on the inside of
frame rails and attach to diagonal brace mounting
holes (5A). Secure using cap screws (13) and
flange lock nuts (14).
Figure 26
. Tail Wheel Installation
Install A-Frame
BB48 & BB60 Cutters:
Attach A-frame bars (2) to the
inside of front mast plates. Secure into position using
carriage bolts (15), sleeves (16), flat washers (17), and
flange lock nuts (14).
Figure 27
.
BB48
and
BB60
Only Assembly
BB72 & BB84 Cutters:
A-frame bars (2) are already
attached to the front mast plates. Rotate up for connec-
tion to diagonal brace bars.
Figure 28
.
BB72
and
BB84
Only Assembly
CD6335B
9
13
5B
13
14
14
13
10
13
5A 4
6
6
28
37
4. Diagonal brace bar
5A. Diagonal brace mounting hole
5B. Tailwheel pivot hole
6. Tailwheel bracket
9. Tailwheel assembly
10. Cutting height bracket
13. 5/8 NC x 2 Cap screw
14. 5/8 NC Flange lock nut
28. Spirol pin
37. 33 mm Flat washer
15
15
17
2
16
1
16
CD6336
Check Chain
Holes
2. A-frame bar
14. 5/8 NC Flange lock nut
15. 5/8 NC x 2 Carriage bolt
16. 5/8 x 1-9/16 Sleeve
17. 5/8 Flat washer
15
15
17
2
2
16
16
Check Chain
Holes
CD6337
2. A-frame bar
14. 5/8 NC Flange lock nut
15. 5/8 NC x 2 Carriage bolt
16. 5/8 x 1-9/16 Sleeve
17. 5/8 Flat washer
(Rev. 5/13/2005)
