Atmospheric Plus Tent
076-2939-6
ASSEMBLY INSTRUCTIONS
IMPORTANT NOTES:
•
Assemble your tent before camping to become familiar with the
assembly.
•
Two people are recommended for setup.
•
Select a clean, level area for the campsites, free of debris and sharp
objects, away from any natural watercourse.
•
Use of a ground cloth is recommended to prolong the life of the tent
floor and provide additional insulation and moisture protection.
•
To prevent damage to the zippers, unzip the doors and windows of
the tent prior to disassembly, allowing air to move freely.
•
Seam-seal the inside stitched seams of the tent. This will improve
weather resistance. Available in sporting goods departments.
Discolouration may occur if applied to outside seams.
Tent: 1 each, with (A) 4 Integrated Airbeams
Steel Stakes: 36 each
1) Stake down the corners by inserting a stake through the stake loops,
locate at each corners.
2) Make certain the tent floor is pulled out evenly and tightly.
3) Hammer the stakes into the ground at a 45° angle using a hammer or
mallet.
Step 2: Peg out the corners
Step 4: Secure the tent
Step 1: Verify package contents
Step 3: Inflate air beams
1) Open the front door.
2)
Locate inflation points on each air beam and unscrew top valve lid.
3)
Insert the pump adaptor which will lock onto the valve.
4)
Inflate all tubes to 7-8 PSI. The tubes should be hand guided into an archway as you inflate.
5)
Final air tube pressure should not exceed 9 PSI. DO NOT OVER INFLATE THE BEAMS!
6)
Start filling the centre beam first and then inflate the others.
7)
Remove the pump adaptor as soon as the air beam is at the correct PSI.
8)
Firmly replace the valve caps on all air beams to create an airtight seal.
9)
Peg out the remaining ground points and guy lines. Ensure that the guy
lines are equally tensioned to provide a stable platform.
1) Secure tent using all guy lines and stakes. Tent must be secured for proper function.
2)
Insert the pole assembly into the sleeve provided in the fly
3)
To finish the tent setup pull the front vestibule away from the tent evenly until it is tight. Close the front door to
ensure correct alignment.
(B)
Canopy Arch Pole 1 each
open
open close
DO NOT INFLATE
ABOVE 9 PSI.
The pressure release valve will
engage once 9 PSI is achieved.
Pressure gauge
Hose
Pressure release valve
close
