STEP 1
STEP 5
STEP 3
STEP 2
STEP 6
STEP 4
www.woodline.co.za
PENDULUM
ASSEMBLY DIAGRAM
1
2
5
5
6
4
4
9
9
9
77
8
3
3
REMOVE ALL BOLTS AT ENDS OF BOOM AND POST.
PUSH SMALL END OF RUBBER SEAL 16” ONTO END OF
POST WITH CRANK. CONNECT BASE SLEEVE AND VERTICAL
POST WITH CRANK AS ILLUSTRATED AND FASTEN BOLTS
WITH WASHERS, THEN SLIDE DOWN RUBBER SEAL OVER
SHORT SECTION OF BASE SLEEVE.
SLOT ELBOW ONTO TOP END OF POST (1), THEN
FASTEN BOLTS WITH WASHERS ON BOTH SIDES.
AS ILLUSTRATED PUSH SMALL END OF RUBBER SEAL 16”
ONTO BOOM, SLIDE POST INTO ELBOW AND FASTEN WITH
BOLTS AND WASHERS. SLIDE RUBBER SEAL OVER ELBOW
TO WATERTIGHT JOINT.
INSERT CRANK HANDLE INTO WINCH AND UNWIND CORD.
THEN GUIDE CORD OVER THE ROLLER THROUGH THE SLOT
IN THE ROLLER HOUSING.
TWO PEOPLE ARE NEEDED TO LIFT AND SLIDE THE
FULLY ASSEMBLED FRAME ONTO PENDULUM SPIGOT.
AS ILLUSTRATED PUSH CANOPY CLIP BRACKET ONTO
BOOM AND FASTEN WITH BOLTS AND WASHERS
SUPPLIED.
C
PROTRADE & WOODLINE cc, 1996
2 /
5
Distributor:
Shadescapes Americas
TEL:970.527.7070
www.shadescapesamericas.com
13
