2
Install-Std-120906
The next few steps are much easier if you have assistance
2 t
rack
i
nStallation
(
See
aDDenDum
for
benDable
i-b
eam
track
)
Need for alignment pins depends on the number of
track sections. Short tracks with a single section will not
have alignment pins or pin slots.
Note:
Some Pairs may have two track sections that butt
together without alignment pins. Not to worry! It’s OK
Door Stacking: DE, LH, RH or Pair
For the purpose of these instructions, doors come in three basic
configurations: Double Ended (DE), Left Hand Stacked (LH) and
Right Hand Stacked (RH). DE doors have Lead Posts at each end
of the Panel set. LH and RH doors have a Lead Post on one end
and a Mounting Panel on the other end. Left or Right handing
is determined when the door is viewed from the front. Pairs are
a set of LH and RH that meet in the middle.
Even and Odd Door Panels
The factory puts in enough door panels to fill the opening. That
seems obvious but it means some doors have an even number
of panels and others an odd number. The consequence is that
the mounting panel on your door may point in the other direc-
tion than those shown in illustrations.
Caution! Firmly attach the track to the structural header!
Sheetrock and many decorative materials do not provide adequate support
There are different installation techniques for Standard (typically single section) Track and Pin (multi section) Track. Compare your
track to the illustration and use the appropriate, following section.
Verify that the track length is correct.
Dry fit the track in the opening. The correct length will just fit. If
needed, trim the track with a hacksaw. Try to keep the metal filings
from mixing with grease inside the track.
If the track is too short by more than ½”, contact Woodfold.
Important: Power Screw Drivers:
Check the length of your #2 Phillips Bit. It needs to extend at least 1¼” past the chuck.
Any shorter and the chuck may tear up the track or the screw won’t seat. It falls into the frustrating category when you
have to order a new track.
Standard Track
(Single Section)
No alignment
pins required
Pin Track
(Multiple sections)
Alignment pins and
pin slots required
Track Comparison
(same dimensions)
Alignment
Pin
Pin Slot
Double Ended
Left Stack - Odd panels
Right Stack - Odd panels
Left Half of Pair - Even panels
Right Half of Pair - Even panels
View
Front View: Lead Post Half Panel to Viewer
1
2
3
1
2
3
4
Mounting Panel to viewer
Mounting Panel away from viewer