Woodfire EVO 20, Руководство по эксплуатации и установке, Страница: 3 / 21

1 Welcome
Dear Customers,
We thank you for your confidence extended to us through the purchase of this wood
burner. Please read this operating manual carefully in order to insure a safe and sensible
handling of the burner. Thus, you may prevent potential damages in advance and achieve
a faultless functioning of the burner for many years.
This burner may only be operated in a suitable environment. E.g. the usage is prohibited in
rooms where work is carried out with solvents, flammable adhesives or coating agents.
The following materials are suitable for burning in this wood burner: wood and wood-
briquettes with a residual humidity not exceeding 20%. Please take care that this level of
humidity is not exceeded, as the burner may otherwise lose a considerable amount of its
performance, and permanent damages may occur.
1.1 Structure of the wood burner
This burner is composed of a welded boiler-steel, or respectively, cast iron casing. An ash
grate is located on the furnace floor, with an ash container below. The combustion
chamber cladding consists of refractory clay or cast-iron plates. In the chimney duct is a
deflector plate which is essential for an optimized flow of the exhausts. The furnace door is
equipped with an inspection window which is especially designed for the use with high
temperatures. The combustion chamber is fed with both primary and secondary air intake.
The primary air intake enters the chamber below the grate – and thus serves as a
performance regulator. The secondary air intake is pre-heated and serves the combustion
of residual gases, while ‘washing’ the interior inspection window in the combustion
chamber, thus preventing the build-up of ash residue.
1.2 Packaging
The wood burner is delivered on a wooden palette in an assembled condition
.
1.3 Assembly of the wood burner
In order to avoid damage due to transport as much as possible, the assembly should be
conducted at its place of destination. Should the burner be installed on a floor made of
easily flammable material, then a fire resistant base has to be used.
For lift door versions, the stove is delivered with the door up in the metal housing. 6 travel
bolts need to be removed from either side of the canter lever mechanism prior to
installation.
When placing the burner, please ensure the sufficient strength of the floor, and that it is
non-flammable.
Page 2