5
Adjusting for Lathe Length
The Woodfast Lathe Stand can be adjusted from
500 mm to 810 mm in length.
1.) Measure the length of your lathe from center of
one bolt hole to the center of the other.
2.) Loosen the two locking bolts (part #16) on the
Outside Extension Support (part# 14) and slide the
Column Supports inward or outward to the desired
length.
3.) Tighten the two locking bolts (part #16) and then
tighten the two locking nuts (part #17). (Fig. 07)
Leveling the Lathe Stand
1.) Loosen the locking nut (part # 3) on the Base
assembly.
2.) Adjust the leveling bolt (part # 2) to the desired
height.
3.) Tighten down the locking nut (part # 3) to retain
the adjustment. (Fig. 08)
Fig.07
Fig.09
Installing the Optional LatheExtension Stand
The Lathe Extension Stand is typically used to
support a lathe bed extension. However, it has
a variety of other uses such as supporting an
accessory table (not included) to hold a grinder or
sharpening system.
1.) Repeat the steps in “Assembling Base to
Column” located on page 3.
2.) Repeat the steps in “Installing Extension
Supports to Base and Column Assembly” also on
page 3.
3.) Loosen and remove the two hex nuts (part #12)
and the two washers (part #11) from the Column
Support on the right side.
4.) Install the Inside Extension Support bracket (part
#15) to the Column Support. (Fig. 09)
Fig.08
Optional Extension Stand
