WoodFast BS250B, Инструкция по эксплуатации

Страница: 8 / 15

1
2
A
B
C
1
B
-7-
3.6 SAFETY DEVICES (Optional)
The machine is equipped with two safety switches as the
picture shown:
A - Safety Switch.
Stops the machine if the upper door or lower door is
opened to perform operations on the blade.
Fig.3.6
4.2 INSTALL OF LOOSE PARTS - INTRODUCTION
A few elements will be disassembled from the machine main structure due to packaging and shipping requirements.
These loose parts should be installed as follows.
WARNING
Please tighten all bolts and nuts absolutely. Otherwise, may cause machine wobble or serious injury to the operator or
other persons.
4.1 INSTALLATION ZONE CHARACTERISTICS
WARNING
It is prohibited to install the machine in explosive environments.
The installation zone must be selected evaluating the work space required depending on the dimension of the pieces
to be machined,and taking into account that a free space of at least 800 mm must be left around the machine.It is also
necessary to check The floor capacity and its surface, so that the machine base is evenly resting on its four supports.A
power outlet and a chip-suction system connection shall be closeto the selected machine setting and it must be
conveniently lighted.
4. INSTALLATION
4.2.1 INSTALL UPPER TRUNNION
- Put the upper trunnion A on to the frame as the picture
shown.
- Put the carriage bolt 1 through the slider B and upper
trunnion A.
- Mount the wing nut C through the washer 2 onto the
carriage bolt 1, and tighten.
Fig.4.2.1
PDF
!"#
"pdfFactory Pro"
$#%&'(
www.fineprint.com.cn
A
A