background image

02

    where is not easily got wet.

5. Do not stand on ceramic toilet.

    the soft-closing damper.

.

     freezing.

     electrical short-circuit.

 CAUTION 

 DANGER 

IMPORTANT SAFETY INSTRUCTIONS

1. Do not install or use the product in wet places as steam room etc.This product must be 

    connected to properly grounded power outlet socket.

2. It is recommended to use water-proof electrical outlet which should be lnstalled in the place 

3. This product should be used with AC 110V-120V,50/60Hz electrical current only,load current 

    is at least 15A. P ower plug must be equipped with ground fault circuit interrupter or ground 

    fault electrical leakage protector or similar high sensitive, rapid type leakage switch 

   (Rated sensitive current under 15mA).

4. When it thunders,it is strongly recommended to pull out the power plug.

6. Ceramic toilet must install floor fixing bolt.

7. Do not stand on product unit,seat and cover.

8. Do not lean against the seat cover when using the product,to avoid damage.

9. This product is equipped with soft-closing seal cover.Heavy pressing or pushing may damage 

10. Do not use lacquer thinner,petrol,liquid medicine,detergent,insecticide,toilet cleanser and 

      scrubbing brush to clean the product.

11.Exposure to direct sunlight is prohibited.

12.Only use tap water or potable water;otherwise it may cause chafing.

13.Do not connect water supply to heater outlet.Make sure inlet water temperature at 3~35

14.When the room temperature is under zero degree,please dry up the water tank,to avoid 

15.Raise rest room temperature to prevent the toilet from damage due to freezing.

16.When move the product from cold or wet environment into normal room temperature,wait for

     2 hours until the condensation water is fully volatilized.Doing so can prevent the product from

17.When not using the product over three(3) days,drain the water out of the container and pull 

     the elelctrical plug from the wall outlet.

18.Stop using the product and shut off the power when product malfunctions,please contact the 

     service people for professional service.

 Indicates that failure to follow the instruction may cause body injury or 

 property damage.

GROUNDING INSTRUCTIONS

This product should be grounded. In the event of an electrical short circuit, grounding reduces 

the risk of electric shock by providing an escape wire for the electric current. This product is 

equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged

into an outlet that is properly installed and grounded.

 Improper use of the grounding plug can result in a risk of electric shock. 

If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to

either flat blade terminal. The wire with insulation having an outer surface that is green with or

without yellow stripes is the grounding wire.
This product is factory equipped with a specific electric cord and plug to permit connection to a

proper electric circuit. Make sure that the product is connected to an outlet having the same

configuration as the plug. No adapter should be used with this product. Do not modify the plug

provided — if it will not fit the outlet, have the proper outlet installed by a qualified electrician. If

the product must be reconnected for use on a different type of electric circuit, the reconnection

should be made by qualified service personnel.

SAVE THESE INSTRUCTIONS

Содержание B0940S
















Отзывы: