background image

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

R

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

WOODBRIDGE 

www.woodbridgebath.com

5

R

WOODBRIDGE 

MODERN ONE PIECE TOILET 

CONNECT TOILET'S TANK

TO WATER SUPPLY LINE

Connect the water supply line between the tank and water 
shut-off valve using a toilet hose (not supplied). When 
connecting toilet hose tighten coupling nut to the tank by 
1/4 turn beyond the hand tight.

Turn on valve on water supply line and allow tank to fill. 
Check all connections for leakages and tighten as needed.

Once tank is filled with water flush it 4-5 times to perform 
a test of the flushing system. At the same time check the 
bottom of the toilet for leaks to make sure that the wax 
ring is properly installed and sealed.

If there are no leaks you are ready finalize the installion. If 
any shims are installed at the bottom of the toilet's bowl 
you may trim them. Apply silicone around base of the 
toilet's. Allow 24 hours for silicone to dry before start 
using the toilet. 

See Figure 6

Important:

 Leaks may not occur during or right after the 

installation. Make sure to check for leaks every couple 
hours first day installed and and occasionally check it 
everyday for the next week to ensure that toilet is properly 
installed and no leaks occur. If any leaks occur immediately 
shut off the water supply line valve and contact your local 
plumber to fix all leaks. 

Important:

Under no circumstances We shall not be liable for any and all incidental damages 
sustained in connection with this product

Neither manufacture, nor distributor, nor retailer is responsible for water 
damage or flood caused due to use of this product.

Under no circumstances We shall not be liable for any and all fees, cost of 
installation/reinstallation/removal, subsequent damage or transportation in case 
of the product defect

Figure 6

INSTALL NEW TOILET

Step 1. 

Lift and carefully put the toilet over the closet 

flange so the closet bolts can go through the mounting 
holes in the toilet's base. Once the bowl is in the position 
press the bowl down with slight twisting motion in level 
position towards the floor. Apply your body weight to 
evenly compress the wax ring to create watertight seal. 
Make sure that the bowl is as leveled as possible to have a 
nice seal tight.

Do not rock the toilet back and forth and side to side as it 
may and will break a seal and you will need to replace the 
wax ring again and start the installation process over.

See Figure 4

Step 2. 

Once the toilet is set and leveled install washers 

and nuts over the closet bolts. Tighten nuts. Do not 
overtighten the nuts. It may and will cause damage to the 
toilet's ceramic base.

See Figure 5

Do not overtighten nut on the tank connection. 
It may and will cause water leakage.

CAUTION!

2 PEOPLE ARE REQUIRED TO LIFT AND DURING
ENTIRE INSTALLATION OF THIS PRODUCT

Note: It may be required to use shims under 
the edge of the toilet's bowl. Due to 
manufacturing process of vitreous china 
ceramic products, every toilet may have 
slight level variations. It does not mean that 
the toilet is defective. In addition your floor 
might be uneven or not leveled as well.

  bolt cap 
decoration

Figure 5

Figure 4

2

1

3

Plastic washer 

W

all

Floor

12"

Rough-in

Standard

W

all

Floor

Содержание B0910













Отзывы: