Fire Deck 8645
Installation and Operation Manual
PG
8
OF
32
M0039.12 DECEMBER 2019
OPTIONAL TEMP CASTER INSTALL
INSTRUCTIONS FOR INSTALLING AND REMOVING OPTIONAL OVEN CASTERS
The Fire Deck 8645 weighs 4,350 lbs.
Do not attempt to move the oven over any type of grade or sloped surface when using the Casters or Pallet Jack.
WARNING:
Failure to follow these instructions may result in severe injury or death. BE SAFE.
If you have any questions call Wood Stone at 800.988.8103.
NOTE: The casters will add 3" to the total height of the oven, for a total of 80-1/4".
The 3-3/4" Vent Shield on top can be removed temporarily if necessary.
Shipping Casters are for moving the oven only.
THEY MUST BE REMOVED ONCE THE OVEN IS IN PLACE.
1
Use a forklift (or pallet jack) to raise the oven
using the front or rear forklift pockets�
3
Once at final destination, use two scissor jacks (or
pallet jack) to lift the one side of the oven by placing
one jack under each caster assembly�
Raise the oven just high enough so the wheels clear
the floor�
Unbolt each Caster and remove it�
Note:
Casters are for moving oven only� They must
be removed once the oven is in place�
4
Lower the oven back to the ground�
Remove the Self-Drilling Screw and slide the rest of
the Caster Assembly out of the fork pocket�
Install Fork Pocket Covers�
Repeat steps
3
and
4
for the other side of the oven�
This oven is designed to be sealed to the floor upon
installation using a silicone sealant acceptable to the
local health official� See the Placing & Installation
section of this manual for additional information�
Caster Bolts
2
Insert a Caster Assembly into each of the side
fork pockets and secure it to the oven with a
Self-Drilling Screw and washer�
Install the screw through the Mounting Tab�
Once the Caster Assemblies are installed, lower
the oven�
It may then be rolled over a
smooth flat
surface to its final destination�
Self-Drilling Screw
& Washer through
Mounting Tab
