Calibrating/Setting Values
Storing New ABC Programs
Press & hold to select
program
Press & hold to delete
old program.
Press & hold to select
program
Enter bottom board size
Push and enter next
board size. Repeat.
Save
ABC Measurements
& hold A, B, or C
Press again A, B, or C.
Input measurements
Save
Set Blade Kerf
Press & hold
Enter value
(2.0mm WM blades)
Save
High/Low Bump Up
Turn on Setworks
As ‘SW-10’ displays,
press & hold
Use arrows to select ‘Hi’ or ‘Lo’.
‘Hi’ = clearance above last board.
‘Lo’ = clearance above cant.
Save
Auto Calibrate Head Height
Set blade height to 150mm
Press & hold
‘Auto Call’ displays
Press. The sawmill will auto-
calibrate itself. ‘End Call’
displays when finished.
Set Input Divider
Turn on Setworks
As ‘SW-10’ displays,
press & hold
Turn on Setworks
As ‘SW-10’ displays, press
LT15 - Enter
20
LT20/40 - Enter
5
Save
Set Actual Blade Height
Press & hold
Enter the correct height
without pausing between
digits.
Save
Height of Head Return
Position head to desired height above cant.
Press until light appears
Press to exit
Verify actual blade height
corresponds with displayed
height.
