Setup & Operation
Operation
Setup & Operation
PGdoc031914
2-16
2
Manual Mode
WARNING!
Always wear eye protection when operating the
grinder. Failure to do so may result in serious injury.
NOTE:
Two modes are available to operate the grinder. For
normal conditions, use automatic mode to set the grinder
up for a cycle and grind the blade (
). Manual
mode may be used to control the grinder functions individu-
ally. You may wish to use Manual Mode when troubleshoot-
ing problems or if you need to make major setup changes.
If necessary, pull the red emergency stop knob out to disengage. Be sure the circuit
breaker switch on the back of the control box is in the on position. Turn the feed rate knob
to zero (0).
When the control displays “Select Mode” push the #2 key to enter manual mode. Alter-
nately, you can scroll through the mode selections with the up/down arrow keys and push
the enter key to select the mode.
After entering manual mode, the display will read “Press Correct Key to Actuate” for three
seconds before displaying the manual control screen. Push the enter key to bypass the
three second delay and enter manual mode immediately.
Manual mode allows the operator to turn on the grinding wheel motor, cam index motor
and/or pump individually as desired. Push the #1, #2 or #3 keys to activate the corre-
sponding function. When the function is on, the box next to the function label on the dis-
play will be solid.
Alternatively, you can start the functions by pressing the green START button. Push
START once to start the oil pump, a second time to start the cam index motor and a third
time to start the grinding motor.
Push the red STOP button to turn all functions off.
Push the escape key to return to the mode select menu.
