Setup & Operation
Operation
Setup & Operation
PGdoc031914
2-12
2
Grinder Operation (Automatic Mode)
WARNING!
Always wear eye protection when operating the
grinder. Failure to do so may result in serious injury.
NOTE:
Two modes are available to operate the grinder. For
normal conditions, use automatic mode described below to
set the grinder up for a cycle and grind the blade. Manual
mode may be used to control the grinder functions individu-
ally. You may wish to use Manual Mode when troubleshoot-
ing problems or if you need to make major setup changes
(
).
See Figure 2-11.
If necessary, pull the red emergency stop knob out to disengage. Be
sure the circuit breaker switch on the back of the control box is in the on position. Turn the
feed rate knob to zero (0).
After the control display reads “Select Mode”, push the #1 key to enter automatic mode.
Alternatively, you can scroll through the mode selections with the up/down arrow keys
and press the enter key to select the mode.
When you enter automatic mode, the control will prompt “Enter Teeth Quantity”. Enter the
desired value from 1 to 999 with the number keys and then press the enter key. If an
invalid value is entered, the display will read “Error: Invalid Tooth # Entry”. Press the
escape key to return to the tooth quantity entry screen.
FIG. 2-11
Feed Rate
Knob
Display
Menu
Start Button
Stop Button
PG0006
1
2
3
4
5
6
7
8
9
0
Number
Keys
Arrow
Keys
Escape
Enter
E
M
ERGEN
C
Y
STOP
