Setup & Operation
Assembly
Setup & Operation
PGdoc031914
2-4
2
Grinding Oil Pump
See Figure 2-4.
Remove all loose items from the oil tray. Remove the oil pump from the box and install the
provided 1/4” FPT hose barb fitting to the pump outlet.
Place the pump and riser plate in the right-front corner of the oil tray and install the mag-
nets to the side of the riser plate.
Route the pump harness through the hole at the rear of the grinder frame. You will need
to temporarily remove the oil hose from the hole to allow the harness connector to fit
through the hole. Route the harness to the connector extending from the harness bundle
located near the index cam and connect.
Reinstall the oil hose through the hole in the grinder frame and connect to the fitting on
the pump.
Fill the oil tray with approved grinding oil available from Wood-Mizer. Fill the tray until the
level is at least 1/2” the height of the pump.
FIG. 2-4
Oil Pump
Riser Plate
Hose Barb
Fitting
Magnet (2)
Oil
Hose
PG0005-3
Pump
Harness
