Operation
Kiln Operation
4
4-7
WMDKdoc020322
Operation
4.5
Kiln Operation
Refer to the appropriate schedule for the timber species and thickness being dried, which
will give you the initial temperature and vent settings to start the process.
WMDK has listed most domestic species and thicknesses under the schedule we feel will
give the best quality drying; however, after using the kilns for a while, you may wish to
alter the schedule depending on the quality of the drying desired.
If the surface of the timber has snow/ice on it, the exhaust should be fully opened with all
the fans and heat on; regardless of the schedule used, until you have a 1-degree
depression. Then resume the normal schedule.
Before the kiln is switched on the Kiln record sheet should be filled out with the full details
of the load, together with the schedule being used.
This is your record of the drying progress and will ensure that the correct rate of drying
and final Moisture Content are achieved according to the schedule.
This record sheet can also serve as a useful after-sales support tool. The Wood-Mizer
branch staff will be able to use it to advise if you are unsure of the progress of your load.
Please note that if you have purchased the 4kW option for drying fast drying species and
wish to dry a slow drying species such as oak, you must set the initial temperature to half
the initial recommended temperature to avoid damage caused by heating the timber up
too quickly.
Содержание MK20-2
