Sawmill Setup
Board Return (Optional)
3
3-16
HD-R04doc041910
Sawmill Setup
3.7
Board Return (Optional)
WARNING!
The board return is intended to assist a second
operator in removing boards quickly. Do not use the board
return when operating the sawmill alone. Serious injury,
death or damage to the equipment may result.
WARNING!
Never use the board return table as a platform
to stand on. This table is designed and intended to assist in
the removal of boards only. Standing on the table may
result in serious injury.
The board return system is optional for non-Super model sawmills. This system consists
of an arm on the saw head that drags the board back when returning the saw carriage. A
board return table is also provided to catch the board as it is removed from the log. Use of
the board return is not recommended with material shorter than 8 foot.
Sawmills before LT40HD Remote Rev. K2.01 Only:
Move the board return table from
the transport storage position at the rear of the mill to the operational position at the front
of the mill. Remove the two pins securing it in its storage position at the rear of the saw-
mill.
See Figure 3-11.
FIG. 3-11
Remove pins and lift
table from storage
position
3H0435
