Sawmill Operation
Cutting The Log
4
4-9
30S97doc041910
Sawmill Operation
4.6
Cutting The Log
The following steps guide you through normal operation of the Wood-Mizer sawmill.
1.
Once the log is placed where you want it and clamped firmly, turn the key switch to the
accessory (#3) position.
2.
Use the blade height scale to determine where to make your first cut
(
The blade height scale will help you to do this. Set the blade to the desired height with the
up/down switch. Make sure that the blade will clear all side supports and the clamp.
Adjust the outer blade guide to clear the widest section of the log by moving the blade
guide toggle switch.
NOTE:
An optional laser sight is available to help determine where the blade will travel
through the log. See the laser sight manual for detailed operating instructions.
3.
Make sure all covers and guards are in place. Start the engine. Engage the clutch/brake
lever (or autoclutch blade switch) to start the blade spinning.
4.
Start the water lube if necessary to prevent sap buildup on the blade.
.
5.
If you want to use the board return function, push the toggle switch on the control panel
down.
6.
Feed the blade into the log slowly
Once the blade completely enters
the log, increase the feed rate as desired. Always try to cut at the fastest speed you can
while keeping an accurate cut. Cutting too slowly will waste blade life and lower produc-
tion!
7.
As you get to the end of the log, slow down the feed rate. When the teeth exit the end of
the log, stop the carriage. Disengage the clutch/brake lever. Remove the slab that you
have just cut from the log.
8.
Use the carriage forward/reverse switch to return the carriage to the front of the mill.
9.
Repeat until the first side of the log is cut as desired. Set aside the usable flitches (boards
with bark on one or both sides). You can edge them on the mill later.
