SETUP & OPERATION
Loading, Turning, And Clamping Logs
2
2-18
25doc092506
SETUP & OPERATION
To Turn Logs
1.
Raise the turner lever to engage the log turner arm. Let the arm rise until it touches the
log and starts to turn it.
2.
Spin the log against the side supports until it is turned the way you want it for the first cut.
If you want to turn the log more, do the following steps.
3.
Engage the clamp by raising the clamp in/out lever. Clamp the log against the side sup-
ports.
4.
Lower the turner lever to lower the turner arm below the log.
5.
Raise the turner arm to get a new bite on the log.
6.
Disengage the clamp.
7.
The log can be turned now. Repeat steps 4 through 7 until the log is turned as desired.
To Turn Logs (Optional Procedure For Hydraulic Mills Except Only)
If you are turning a small cant on a Super Series mill, you may opt to use the clamp to
turn the cant.
1.
Lower the clamp up/down lever to lower the clamp below bed level.
2.
Raise the clamp in/out lever to move the clamp in, beneath the edge of the cant.
3.
Raise the clamp up/down lever to raise the clamp and flip the cant.
