SETUP & OPERATION
Blade Support Arms Installation
2
2-3
BMS500/600doc121319
SETUP & OPERATION
DANGER!
It is recommended that a 30mA GFI (Ground Fault
Interrupter) be used.
2.2
Blade Support Arms Installation
The industrial sharpener is equipped with two side blade support arms with blade support guide
assemblies.
To install the support arms, first apply grease to their threaded ends. Then insert the arms into the
threaded holes on both sides of the sharpener.
1.
Each guide assembly includes a blade support with post, a blade support without post, two bolts,
a locking nut and a wing nut.
See Figure 2-3.
To install the blade support guide assemblies, join each of them around one blade
support arm. Face the post outward as shown. Connect the both parts of the assembly using the
provided hex head bolts. Bolt from the hexed side of the blade support guide assembly (these
hex-shaped holes will keep the bolts from turning once in place). Secure the bottom bolt with a
locking nut. Secure the top bolt with a wing nut.
2.
Tilt the guides on the left blade support arm slightly backward, toward the rear of the sharpener.
Tilt the guides on the right support arm slightly forward, toward the front of the sharpener.
3.
The blade support guide assembly can be positioned at any location on the blade support arm,
depending on the blade length. The side blade support arms can be adjusted horizontally if
necessary. All blade support arms can be adjusted up or down, depending on the blade width.
BMS500H(S/U)
BMS600H(S/U)
3 x 400V
10 Amp
minimum 1.5 mm
2
(min. 15 AWG)
FIG. 2-3
TABLE 2-1
Support Assembly
Blade Support Arm
CESH04
Blade Support Guide
Assembly
Blade Support Arm
