Wolturnus E-Hockey User’s Manual 2019
Sports Wheelchair
Adjusting the Wheelchair
6.4 Seat length and seat shape
The seat length is adjusted by removing the seat cushion and loosening the Velcro (Image 7) on the front part of
the seat cushion from the rear part and pushing or pulling it to the desired position (Image 8). The front part of
the seat week is then fixed again on the rear part.
The seat recess is adjusted by removing the seat cushion and removing the front seat cushion (Image 9). Pull the
seat backwards so that the velcro straps on the underside of the seat are available. Release the Velcro straps
(Image 9 and 10) tighten them properly before re-attaching them (image 10). Note that for most users, the straps
should be tighter against the front edge of the seat than towards the rear edge. This provides better resistance
to the backrest’s forward-facing pressure on the lower body and a better positioning of the hip. We recommend
that this setting be initially performed with the assistance of Wolturnus A / S consultants or the user’s therapist.
Image 7
Fold the sideguards down into the
seat.
Image 8
Tilt the back down
Image 9
Detach the rear wheels
Image 10
Ready for transport and storage.
6.5 Sideguards with Armrests
The height of the armrests is adjusted by loosening and removing 2 pcs. screws with 4 mm Allen key, which at
-
tach the armrest fitting to the side piece (Image 11). Then the side piece is fastened again in another position so
that the desired armrest height is achieved.
Image 11
Loosen Screws
6.6 Control panel Position
The standard mounted control panel position can be set to the user’s needs in several ways.
1.When loosening the two screws on the mounting bracket (Image 12), the control panel can be moved forward
or back to the desired position, then the screws tightened again. The height of the control panel can change by
disassembling 2 pcs. screws (Image 14) and move the bracket to another position.
2. By loosening the screw at the front of the joystick support arm (Image 13), the control panel can be moved up
or down and rotated for precise optimization of the user’s operating position.
3. If further adjustment of the control panel position is needed in the longitudinal direction, the two screws on
12