Manual, for Fixation of Wheelchair in Motor Vehicles 2018-2019
Active Wheelchair
14
5
.5 Use of the Dahl Docking station: Manual release in Case of Electric Failure
The following points will describe how to release the wheelchair in a motor vehivle with a Dahl Docking station in
case of eletric failure:
1.
In the event of electrical failure, a manual emergency release is located at the front edge of the docking
station. Move the wheelchair forward to release presure on the lock pin and push the red release arm to
one side and hold it there while the wheelchair reverses out of the docking station.
2.
A cable-activated manual operating lever can also be fitted (optional). The red release arm must be pushed
to one side and should be held there whilst the wheelcahir moves away.
3.
If the described manual release procedures fail, an emergency release tool made from red plastic comes
with each docking station. Move the wheelchair forward to release presure on the lock pin and place the
emergency release tool in the gap between the locking plate and the docking station. Push the release tool
and wheelchair forward untill the locking pin will be forced down – after which the wheelchair can be rever
-
sed out of the docking station (see image 12 and 13).
5
.6 Safety-belt with Dahl Docking
When using wheelchair with Dahl Docking system, the floor anchorage points for the occupant restraint system
should be located 10-60 mm outside wheels, on each side. The pelvic belt must be worn low across the front of
the pelvis so that the angle of the pelvic belt is within the optional or preferred zone of 30° to 75° as shown. A
steeper (greater) angle within the preferred zone, 45° to 75° is desirable i.e. closer to, but never exceeding 75°
degrees (see image 14).
Image 14 Safety-Belt with Dahl Docking
Image 12 Dahl Docking Manual Release
Image 13 Insert Release Tool
Содержание A-RUN
Страница 2: ......