1
Ceiling Tile
EYE Series Mounting Kit
Part 1: Tile Bridge Installation
The Ceiling Tile Bridge is designed to support the WolfVision EYE Series models only. T-Grid ceilings are not
designed to support weight loads – support wires must be attached to the structural ceiling above. It is the
responsibility of the installer to ensure this product is properly supported and meets all local building codes
and plenum requirements. Make sure the ceiling structure is capable of holding at least 12 lbs. (4x the
combined weight of the mount and camera).
Steps:
I
Inspect Installation Location
1)
Determine mounting location within T-
grid ceiling based upon the center of the
desired focal point on the working
surface.
Note:
An adjacent tile will also have to
removable for access.
2)
Verify structural support (T-grid wire
above the ceiling tile). Check overhead
clearance. A minimum of 8
1
/
2
’’ above
Ceiling tile is required. After you have
verified all clearances, replace the ceiling
tile.
Note:
Center of installation must be at least
3
11
/
16
’’ from both ceiling grid structures
to allow for hole clearance.
8
½
’’
3
11
/
16
‘’
3
11
/
16
‘’
