7
Helpful Hints
• Use the flat beater for a variety of mixtures, including cakes,
frostings, biscuits, breads, pastry and cookies.
• Use the wire whisk to incorporate air into mixtures, such as egg
whites, boiled frostings, mayonnaise and sponge cakes.
• Use the dough hook for mixing and kneading bread and other
yeast doughs.
• Never scrape down sides of bowl while mixer in in operation. If
scraping is necessary, first turn the mixer OFF.
• When mixing dry ingredients, always start off at the lowest speed
to avoid splattering.
• When making meringues, the mixer bowl and wire whisk must be
very clean and dry.
• When making whipped creams, first chill the bowl and the whisk.
• Do not overknead dough. Overkneading will prevent the dough
from rising.
Care and Cleaning
1. Make sure speed selector dial is turned to OFF and mixer is
unplugged.
2. Raise mixer head to up locked position.
3. Remove bowl and attachments.
4. Bowl, flat beater, and dough hook may be washed in hot, soapy
water or in automatic dishwasher. The wire whisk should be
washed by hand in hot, soapy water. Dry all parts thoroughly
before storing.
5. Wipe head and base of mixer with a damp cloth.
6
Using Accessory Attachments
A number of optional accessory attachments are available for use with
your stand mixer, including a meat grinder and sausage stuffer. See
the following general instructions for assembling and removing these.
Assembling Accessory Attachments
1. Ensure stand mixer is turned off and the unit is unplugged.
2. Grasp the front cover of the mixer head from underneath and
remove hub cover by pulling upwards.
3. Insert the shaft of the accessory into hub ensuring that the
accessory stands vertical in the hub. When properly inserted, the
two guides on either side of the accessory will be lined up with
the guides on the stand mixer hub. If the accessory does not stand
vertically in the hub, and does rest against the hub, pull the
accessory out slightly and turn to the left or right while pressing
into the mixer until the hub catches the stand mixer gear.
4. Remove the black rubber plug from the side of your mixer and
insert the locking knob. Once the accessory is properly attached,
tighten the locking knob by hand until secured in place. (Note:
Your locking knob will not lock the accessory in place if it is not
properly attached to the stand mixer.)
Removing Accessory Attachments
1. Turn stand mixer off and unplug from outlet.
2. Loosen the locking knob on the side of the mixer by turning
counterclockwise. Remove.
3. Pull the attachment out from the stand mixer while gently rotating
it left and right.
4. Insert black rubber plug into the locking knob hole.
5. Affix hub cover to the front of stand mixer with gentle pressure.
