
21
EN
5.0 Ending the work
► After completion or interruption of work, make sure
that the machine is level and does not tilt back-
wards. To counteract a deformation of the still
hot rubber coupling.
► After ending the work and when leaving the machi-
ne, the mains plug-in must always be removed
from the power outlet.
6.0 Maintenance
6.1 Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
► Clean the cooling fi ns of the motor and electronic
system on a regular basis.
Once work has been completed, the clamping devices
must be disassembled and the machine cleaned.
The machine must then be sent to an after-sales Ser-
vice agent. Addresses are listed in the Section “After-
sales service and customer assistance”.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specifi ed on the
type plate of the machine.
6.2 Spare parts
Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
7.0 Trouble shooting
Fault
Possible cause Remedy
8.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline
Machine does
not run smoo-
thly
Imbalance
The segments have
not been distributed
evenly over the seg-
ment disc
Machine
does not
start
Power supply
disconnected
blown fuse
defective cable or
plug
Emergency stop is
locked
Machine overloa-
ded
Have machine
repaired by a quali-
fi ed electrician,
resp. change parts
Unlock by turning to
right
Tilt the machine over
the transportation
wheels. The plate is
unloaded. Slowly on
the fl oor
Machine
switches off
during work
Machine overloa-
ded
After work, with red
LED:
Wait until the motor
has cooled down,
apply more diamond
segments if required
to reduce the sanding
pressure, and remove
additional weights if
required
Содержание 076970
