9
P R E S E T P R O G R A M M I N G M O D E
The preset temperatures can be adjusted for
the Proof, Low, Medium and High settings.
To Adjust Preset Temperatures:
Warming drawer must be in OFF mode.
Touch and hold PROOF.
While holding PROOF, touch ON/OFF,
then release both pads.
To adjust the temperature while in preset
programming mode, touch either the UP or
DOWN arrow until the desired interval is
shown in the LED display.
Touch the pad lit by the red LED. When the
temperature is raised or lowered to the next
defined preset range, the LED next to the
corresponding range will be lit. Refer to
Temperature Ranges on page 8.
Touch ON/OFF to exit this mode and save
the new settings to memory.
NOTE: The preset programming mode is
saved, so if power is interrupted the latest
intervals entered will be retained.
P R E S E T R E S T O R E M O D E
Any changes that are made to the controls of
the warming drawer can be restored back to
factory preset conditions without changing
each individually.
To Restore Preset Temperatures:
Warming drawer must be in OFF mode.
Touch and hold both the UP and DOWN
arrows.
While holding both the UP and DOWN
arrows, touch ON/OFF, then release all
pads.
The letters "ini" will appear in the LED
display, indicating that the temperature
presets and automatic shut-off timer have
been restored to factory presets.
Touch ON/OFF to exit this mode and save
the new settings to memory.
S A B B A T H M O D E
In Sabbath mode, the automatic shut-off is
disabled, allowing the unit to run continuously.
Initiating Sabbath mode is accomplished
through automatic shut-off adjust mode.
To Initiate Sabbath Mode:
Warming drawer must be in OFF mode.
Touch and hold the DOWN arrow.
While holding the DOWN arrow, touch
ON/OFF, then release both pads.
The last programmed automatic shut-off
time interval along with the letters "hr" will
appear in the LED display, indicating that
the unit is in automatic shut-off adjust
mode.
Touch the DOWN arrow pad until "0 hr"
appears in the LED display.
Touch ON/OFF to exit automatic shut-off
adjust mode and save the new setting to
memory.
The warming drawer is now in Sabbath
mode, it will operate continuously until
ON/OFF is touched.
Set the temperature for the warming
drawer. Refer to Temperature Settings on
page 8.
To exit Sabbath mode, repeat steps above
for initiating Sabbath mode using one to
four hours as the time limit for the warming
drawer to operate.
NOTE: The automatic shut-off time interval is
saved, so if power is interrupted Sabbath
mode will be retained.
W O L F
WA R M I N G D R AW E R
U S E & C A R E
When Sabbath mode is initiated, the
automatic shut-off feature is disabled,
requiring the unit to be turned off
manually by touching ON/OFF.
