Wolf Transition, Руководство по установке

Страница: 3 / 12

3
LAYOUT AND PLANNING THE INSTALLATION
1.
Take inventory of the cabinets as per the plan or order.
2.
Find the high spot in the floor using a level as shown below.
Locating the High Point on the Floor for a Wall
Locating the High Point on the Floor Between Two Walls
Locating the High Point on the Floor for an Adjacent wall
Wall
3.
Measure up the wall 34 ½" above the high spot
and draw a level line anywhere that base
cabinets will be installed. (This means that this
line will measure greater than 34 ½" above the
floor in most places along the wall.)
4.
Find and mark the studs. This can be done
by trial and error of driving a nail in the wall
until you find a stud or use an electronic
stud finder. Studs will usually be every 16"
center to center.
Place a mark 34 ½" up from the high spot in floor.
High point of floor wall 1
High point of floor wall 1
High point of floor wall 1
High point of floor wall 2
High point of floor wall 2
2 I N S T A L L A T I O N G U I D E