Fryer Module Specifications
5
wolfappliance.com/specs
IMPORTANT NOTE:
This appliance must be installed in
accordance with National Electrical Codes, as well as all
state, municipal and local codes. The correct voltage,
frequency and amperage must be supplied to the appli-
ance from a dedicated, grounded circuit which is
protected by a properly sized circuit breaker or time delay
fuse. The proper voltage, frequency, and amperage ratings
are listed on the product rating plate located on the under-
side of the module. Refer to the illustration on page 3.
The complete appliance must be properly grounded at
all times when electrical power is applied.
Do not ground the appliance with the neutral (white)
house supply wire. A separate ground wire must be
utilized.
If aluminum house supply wiring is utilized, splice the
appliance copper wire to the aluminum house wiring
using special connectors designed and agency certified
for joining copper and aluminum. Follow the connector
manufacturer’s recommended procedure carefully.
Improper connection can result in a fire hazard!
Electrical Requirements
Verify that power is disconnected from the electrical
box before proceeding.
The Wolf electric fryer module requires a separate,
grounded 3-wire electrical supply with its own circuit
breaker. Locate the electrical supply within the shaded
area shown in the installation illustration on the following
page.
MODEL IF15/S
•
Power supply:
240/208 V AC, 60 Hz, 15 amp service.
•
Max connected load:
2.6 kW at 240 V, 1.9 kW at 208 V.
The fryer module is provided with a 4' (1.2 m) flexible
3-wire conduit that makes a connection to a junction box.
The conduit consists of two insulated hot lead conductors
and one insulated ground conductor.
IMPORTANT NOTE:
You must follow all National Electrical
Code regulations. In addition, be aware of local codes and
ordinances when installing your service.
For electrical installation, attach the conductors to the
residence wiring in accordance with National Electrical
Codes and all state, provincial, municipal and local codes.
The wiring diagram covering the control circuit is located
inside the module control box.
