4
To insert batteries use philips screwdriver and open 2
screws on battery compartment. When inserting new
batteries always replace all of them and turn off Alarm
before replacing. After use of HUBB if not going to be used
for a while it is recommended to remove batteries in case of
leakage.
INSERTING BATTERIES
To return the HUBB to factory
settings, and clear all user data,
power the HUBB off, and then
power it back on while holding the
key. keep holding the key until
the following is displayed.
When the HUBB is turned off,
Press and hold
for 2 seconds.
Release
to begin the start-up
sequence.
POWER ON
Good battery level
OK battery level
Bad battery level
From any screen, press and
hold
for 1 second. LED will
illuminate Blue.
Release
to power off.
POWER OFF
FACTORY DEFAULT
TORCH
From any screen, press and hold to illuminate all LED’s
as a torch function. WARNING - avoid direct viewing into
LED when illuminated.
BUILT-IN STAND
Built in Stand
allows you to place
you Hubb of your
Bivvy Table or
foldaway to allow
you to place in your
pocket.
4 AA 1.5v
Batteries
Built in
stand
