Wolf ICBDD36, Инструкция по использованию и уходу

Страница: 6 / 44

6
|
English
DOWNDRAFT OPERATION
Downdraft Operation
CONTROL MODULE
1
To activate the downdraft, press the button. The
drowndraft chimney will elevate and the blower will turn
on automatically to low speed. Refer to the illustration
below.
2
To adjust the blower speed, press the , or
button. The corresponding LED will illuminate to indicate
blower setting.
3
To initiate boost mode, press and hold the button
for 5 seconds. Boost increases airflow by approximately
20% more than high but is limited to 10 minutes. After
10 minutes, the blower will automatically transition to
high.
DELAY FEATURE
The delay feature continues blower operation for approxi-
mately five minutes after use, then automatically turns off.
If the blower was operating on high or medium speed,
the blower will transition to the next lowest setting for five
minutes before turning off. The chimney will stay up until the
button is pressed.
FILTER INDICATOR
After approximately 30 hours of operation, the LED will
illuminate to indicate filters need to be cleaned. Refer to
care recommendations.
To reset the filter indicator, press the button. Refer to the
illustration below.
Control module.
CONTROL MODULE BUTTONS
DELAY MEDIUM
FILTER LOW
HIGH+ UP/DOWN
Filter Removal
To remove filters, push down on the filter while pulling the
filter forward and away from the downdraft. Refer to the
illustration below. Reinstall using the reverse procedure.
The filters are dishwasher safe. Refer to care
recommendations.
IMPORTANT NOTE:
Do not operate the downdraft without
filters.
MEL
T
HIGH
OFF
ON
OFF
ON
SIM
HIGH
OFF ON
SIM
HIGH
BRID
GE
OFF ON
SIM
HIGH
ZON E 2
CLEA
R
OFF
O
ZONE
2
ZONE
3
HIGH
SIM
OFF
ON
Filter removal.
CARE RECOMMENDATIONS
Care Recommendations
CLEANING
Stainless
steel Use a nonabrasive stainless steel cleaner and
apply with a soft lint-free cloth. To bring out the
natural luster, lightly wipe surface with a water-
dampened microfiber cloth followed by a dry
polishing chamois. Always follow the grain of
stainless steel.
Control
module Use spray degreaser to remove fingerprints and
food soil. Spray on a cloth before wiping panel.
IMPORTANT NOTE: Do not spray cleaners
directly on the control module.
Filters Place filters and filter covers into the dishwasher
at approximately 160°C, or hand wash using a
biodegradable detergent.