Wolf e Series, Руководство по установке

Страница: 5 / 44

wolfappliance.com | 5
Installation
Place the oven in the opening and slide back.
Locate the mounting holes on the oven side trim, two on
each side. Drill 1/16" pilot holes. Use the provided mounting
screws to secure the oven to the cabinetry. Refer to the
illustration below.
To avoid interference, a 90° door stop may be required for
any appliance or cabinet door installed next to the oven.
CAUTION
Failure to install the mounting screws may cause the
oven to tip forward during use.
Installation
OVEN DOOR REMOVAL
To remove, open the oven door completely. Rotate both
hinge latches forward to the open position. Close the door
to approximately 30° open, then lift up and out. Refer to
the illustrations below.
To reinstall, insert door hinges into the frame openings.
Open the oven door completely and rotate both hinge
latches back to the closed position.
Preparation
Before moving the oven, protect any finished flooring and
secure the oven door(s) closed to prevent damage.
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.
CAUTION
Do not lift the oven by the door handle. This will
damage the oven door and hinges.
Electrical Connection
WARNING
Verify power is disconnected from the electrical box
before proceeding.
If the electrical supply is located in the opening, the
electrical connection must be made prior to placing the
oven in the opening. If the electrical supply is in an adja-
cent cabinet, the electrical connection can be made after
placing the oven in the opening.
1 Connect the brown appliance wire to L1.
2 Connect the blue appliance wire to N.
3
Connect the green/yellow appliance wire to .
CLOSED
POSITION
Oven door hinge latch
Door open 30°
MOUNTING
HOLES
Oven installation