wolfappliance.com
|
11
Installation
PREPARATION
Remove and recycle packing materials. Remove labels and
protective plastic film from the grill.
Place briquette trays in the grill above the burners with flash
tubes positioned at the front. Refer to the illustration below.
Place burner grates directly above the briquette trays with
square openings in the grates at the front.
POWER TRANSFORMER
For built-in installation, secure the transformer box in a dry
location, away from the grill firebox and excessive heat area,
but within 2'
(.6 m)
of the right rear opening. Do not install
the transformer box inside the insulating liner.
For cart installation, mount the transformer box by the two
screws located at the bottom right rear corner of the grill
cart, behind the pull-out shelf. Utilize the same transformer
for the side burner if installed.
FLASH TUBE
Flash tube position
CART INSTALLATION
1
T
wo mounting screws are provided at the bottom right
rear corner of the cart for the power transformer. Install
the transformer box.
2
Remove front mounting screws from the cart. Place grill
onto the cart, allowing enough space at the back to
make connection to the transformer.
3
Make connections from the wiring harness located at the
right rear of the grill to the transformer, then slide the grill
back until it is fully engaged with the cart.
4
Secure grill to cart with four screws provided. Mounting
holes in the upper back corners of the grill will align with
holes in the cart. Secure with two screws. Remove the
drip tray. Install two screws through side mounting holes
below the grill front panel and into the cart.
INSTALLATION
