18
Operating instructions lawnmower
English
Operation
Insert the threaded bolts
into the quick-
clamping levers
so that the holes can be
seen
. Hold them firmly between thumb and
index finger and screw on the quick-clamping
levers and threaded bolts clockwise
until
they are at a distance of ~10 mm
.
Attach the upper part of the handlebar by folding
the quick-clamping lever upwards
.
You can adjust the handlebar, depending on
your height, to three required working positions
(
I
/
II
/
III
–
) by loosening the two lower quick-
clamping levers
and by changing the inclina-
tion of the assembled handlebar until the required
height has been reached
. When the handle-
bar has been set to the required height, fold the
lower quick-clamping levers upwards
.
Fasten the power cord to the lawnmower
by attaching it with a cable clamp
in the position shown in Fig.
(see arrow).
Take the cable strain relief
and hang
it by the large opening on the WOLF-Garten
Flick-Flack
®
cable guide
.
Finally insert the WOLF-Garten Flick-Flack
®
cable guide into the two eyes on the left and right
sides on the upper part of the handlebar
.
You have the option of folding the handlebar
to facilitate transportation and storage.
Further information can be found in the chapter
“Transportation and storage”.
Attaching the grass catcher bag
Attach the grass catcher bag according to Figures
and
as follows:
Grip the frame on the handle
with one hand
and pull the fabric catcher bag over the long end
of the frame
with the other hand. Guide the
fabric catcher bag with its profile under the handle
on the frame and attach the profile of the fabric
catcher bag to the frame under the handle
.
Then attach the side profiles of the fabric catcher
bag to the frame. Start with the two lowest profiles
. Then attach the two small profiles above
them
and finally the two profiles on the left
and right under the handle
(see arrows).
Then turn the grass catcher bag over and first
attach the profile under the chute
and then
the profile next to the chute
on the lower
part of the frame.
Operation
Operating times
Observe the regional regulations.
Enquire at your local authority regarding
the operating times.
Guiding cable into the cable strain relief
Please guide the cable into the cable strain relief
according to Fig.
. How the cable is fastened
depends on its diameter.
If the diameter of the cable is less than 6.5 mm,
insert the cable from below through the cable
strain relief and first pull over the left and right
hooks and then over the middle hook of the cable
grip.
If the diameter of the cable is greater than
6.5 mm, insert the cable from below through
the cable strain relief and pull over the left and
right hooks only.
Information on the WOLF-Garten
Flick-Flack
®
cable guide
The WOLF-Garten Flick-Flack
®
cable guide keeps
the cable away from the cutter deck
.
Attaching the grass catcher bag
Attention! Rotating cutter bar!
Do not make any adjustments to the lawn-
mower until the motor has been switched off
and the cutter bar has come to a standstill.
Lift the discharge flap
.
Grip the grass catcher bag by its black handle
and tilt it slightly so that you can hook the grass
catcher bag into the recesses in the back of the
lawnmower
(see arrows).
Hook the grass catcher bag into the lawn-
mower
.
Fold the discharge flap down again
.
