Wolf Garten 2.38 E, Инструкция по эксплуатации

Страница: 13 / 30

12 13
Assembly
Operation
Maintenance
Cleaning
Note: Disconnect electricity by unplugging cable
at the socket before proceeding. Attention: Keep
hands clear of moving blade.
Clean mower thoroughly after each mowing with cloth or
brush.
Do not spray with water.
Winter Storage
• Clean mower thoroughly before storing away.
• Have your mower thoroughly checked once a year by an
approved Service Centre.
•
Do not store it in a wet or humid place.
Change of cutter blade Q
Note: always disconnect mains supply and wear
protective gloves before undertaking any work at
the cutter blades, cutter bar and blade coupling.
Change cutter blade using 13 mm spanner as illustraded.
Torque wrench setting for screws 16-18 Nm. Take care to
carry out this work thoroughly. Use original spare parts only.
Note: Sharpining of blades should be done by an
approved service centre as the correct balance of the
blade after sharpening is very important and ought to
be checked by an expert.
Adjusting the Bowden cable coupling R
1. Raise the drive bracket (1) app. 2 cm and hold.
2. Loosen the locking nut (2).
3. Turn the setscrew (3) left until the drive wheels are blocked
when you pull the mower backwards.
4. Tighten locking nut (2).
Operating times
Please check noise abatement regulations prevailing in your
country.
Adjustment of cutting height
N
Only when mower is stationary and rotating blade
has come to complete standstill.
1. Press button (1).
2. push chassis downwards or pull upwards, as required.
3. Release button at required cutting height (2).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do not
se cutting position too low when mowing very hight or wet grass.
We recommend an average cutting height of 4,0 - 5,0 cm.
Connecting to the mains
(230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains
supply, provided with a 16 Amps. fuse.
Note: Use a residual current device (RCD) rated for a
residual current not greater than 30 mA.
Starting and Stoping O P
• Switch on motor with mowerplaced on level and firm ground
• not in high grass - alternatively tilt slightly
O
.
Switch-on motor
P
1. Depress button and hold (1).
2. Lift up bar (2).
3. release button (1).
Wheel drive on (only 2.40 EA)
P
Raise drive bracket (3).
Wheel drive off (only 2.40 EA)
P
Release drive bracket (3).
Switch-off motor
P
Release bar (2).
Tips for mowing
• Always let cable trail on the cut side of the lawn.
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters.
Inserting power cable into cable holder
L
Insert the power cord into the strain relief as shown in the
illustration.
Hanging the grass bag M
Only when the motor is not running and the
cutting blade is not moving.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the
recesses (see arrow).
3. Replace the protective flap.
Emptying of Grassbox
The grassbox is full and should be emptied as soon as
grass clippings remain uncollected on the ground behind
your mower.
Note: Disconnect electricity by unplugging cable
at the socket-before proceeding.
Fixing of handle A B C D E
ATTENTION! Take care that theswitch cable does not
become caught and crused when folding the handle frame.
Mount grass catcher F G H J K
See illustrations.