9
Unpacking and Set-Up Instructions
Unpacking/Parts Breakdown
Inspect for any signs of freight damage. If obvious damage is detected, contact the freight
company and file a damage complaint. It may be necessary to take pictures of the damage.
After visual inspection make sure all of the proper components have been received.
Determining if assembly is required will depend on the method of shipping. The wheelchair is
shipped two different ways. The wheelchair ships completely assembled or the casters and
wheels must be bolted on after delivery.
Items enclosed in the boxes:
Chair Frame w/ upholstery
Rear Wheels
Front Casters
Front Caster Bolts
Rear Wheel Bolts
Leg Rests
Tools required for assembly:
2 - 1/2” Open End Wrench
2 - 15/16” Open End Wrench
Wheelchair Set-Up
The Advantage wheelchair has two adjustments for the seat to floor height, determine which
height is suitable for your situation. If the top hole is used on the casters, be sure to use the top
hole on the wheels.
To bolt on the back wheels, slide the bolt through the wheels and then add the spacer. Attach
wheel assembly through the frame and secure the nut with a 15/16” wrench. Be sure to put the
bolt through the same (top or bottom) hole on both sides.
Slide the caster up into the frame of the chair, slide bolt in through the pre-drilled hole. Attach
nut with a 1/2” wrench. Be sure to put the bolt through the same (top or bottom) hole on both
sides.
DO NOT discard any packing material until all components are accounted for and are in good
condition.
WARNING:
Failure to follow the set-up instructions could result in user injury
as well as damage to equipment or other property.