© 2004 Wohler Technologies Inc. ALL rights reserved
14
AMP2-VSDA/AV
and
AMP2-VSDA/AM
User Manual P/N
821576
Rev-
B
Rear Panel Features
Section 2:
Operation
High (+)
Low (-)
Gnd
(Shield)
Pin-1
Pin-2
Pin-3
Pin-1
Gnd
(Shield)
Pin-2
High (+)
Pin-3
Low (-)
Female XLR Pinout
Male XLR Pinout
(Continued)
H
I
J
K
AES Input Level Gain Calibration DIP Switch
Input
Level Gain Calibration
, the analog level which corresponds to a given digital input value, is settable via this DIP
switch. The factory setting is +4 dB (analog) = -20 dBFS (digital). See the silk-screened chart on the rear panel or the
diagram below for
Level Gain Calibration
settings.
Converted Analog Out Connectors (1-4)
These four Phoenix connectors output
analog
signals converted from the selected digital inputs (but not the
Analog
inputs
). These ouputs are
not
affected by the position of the
Analog/Digital Source Select Switch
(
Item 8
, page
8
).
These 3-pin male Phoenix connectors are configured for a balanced low impedance connection. Phoenix connector pin-out
information is silk-screened just above these connectors on the rear panel (see
Figure-2b
).
Selected Analog Output Connectors
These two 3-pin male XLR connectors are
analog
outputs of the selected source(s) as assigned to the left and right
speakers. The left connector outputs the left channel (
Channel A
) and the right outputs the right channel (
Channel B
).
Both connectors are configured for low impedance connections and the output signals are not affected by the volume/
balance controls or headphone mute. For XLR pinout information see the diagram below.
Analog Input Connectors (CH. 1 - CH. 4)
These four 3-pin female XLR connectors accept standard
analog
audio signals and are configured for balanced 70K
Ω
connections. For XLR connector pin-out information, see the diagram under
Item J
. Note that the
Analog
inputs are
monitored
only
when the
Analog/Digital Source Select Switch
(
Item 8
, page
8
) is set to
ANALOG
.
